3D Print a Model BlackFly

Assembly Instructions

3D Print STL files

  • 0.2 mm layer height
  • 0.4 mm nozzle
  • PLA
  • 15% infill

Required tools

  • Super Glue
  • Small file or sandpaper

Overview of components

  • Left half
  • Right half
  • Left Winglets
  • Right Winglets
  • Alignment plugs

Confirm fit

  • Dry fit all the pieces together
  • File or sand if required

Glue the two halves together

  • Insert 2x alignment plugs into one half
  • Apply Super Glue to other half
  • Align halves and press together until Super Glue sets

Install two Right Winglets

  • Apply Super Glue to end of wings
  • Install each winglet (note orientation!)
  • Press together until Super Glue sets

Install two Left Winglets

  • Apply Super Glue to end of wings
  • Install each winglet (note orientation!)
  • Press together until Super Glue sets

Enjoy your Model BlackFly!

License ©
  • Sharing under same license with attribution allowed
  • Remix allowed
  • No commercial use